|
|
 | | Re-reply: 9v motor dying
|
| Thanks everyone for the info. I ran it again today. Slowed down and stopped. I smelled it and there was an odor of over-heating (burning sounds too dramatic), that my other motors do not have. I waited 5 minutes, tried it again. This time, it ran (...) (24 years ago, 30-Nov-00, to lugnet.trains)
| | | | | Re: 9v motor dying
|
| In playing... I accidentaly discovered a way to break in and loosen up neew engines. Using a battery box from my 8480 shuttle... The torqe is incredible. But do be careful, short runs only. That much amperage is a bit warm. Fred (24 years ago, 30-Nov-00, to lugnet.trains)
| | | | | Re: Tank Car Sketch
|
| G'Day Damm you guys are fast ! I was just doing the same thing and though (ha!) that I would be the first to post. (ha!) Anyway, my version came out about the same. This just shows the foresight of moving to 8 wide ! (grin/duck) Hopefully oneday we (...) (24 years ago, 30-Nov-00, to lugnet.trains)
| | | | | Re: 9v motor dying
|
| (...) My guess is that the grease has dried up and the things slowly seizing up. As it heats up it causes my friction etc... As for a train motor, same thing I'd wager. The Train motors have a little metal heat switch that breaks the current when it (...) (24 years ago, 29-Nov-00, to lugnet.trains)
| | | | | Re: Lifespan of a motor?
|
| (...) I too have been running the motors in extended periods of time, but it has always been at full speed. Have you been running them for lengthy periods at very low speed with a PWM controller? This is an issue since some motors have a tendency to (...) (24 years ago, 29-Nov-00, to lugnet.trains)
|
|
