 | | Re: ME Models Metal Rails
|
|
(...) Numbers are: R56, R72, R88 where R40 is LEGO standard. Number corresponds to radius of curve on center of ties. The pattern CURVE-STRAIGHT-CURVE...IGHT-CURVE will match up with 4 sections of R72 perfectly. (13 years ago, 4-Apr-11, to lugnet.trains, FTX)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) end ties will be produced in? I'd like to see light bley, as well as brown, and possibly tan? ROSCO (13 years ago, 4-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) Yup. What I'm hoping is that they are making a radius that matches the radius of the straight-curve-straight-curve corner, so we can simply drop them in and laugh:-) JOHN (13 years ago, 4-Apr-11, to lugnet.trains, FTX)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) TCLTC and PennLUG are in the same boat John. Our steam fleet will look fantastic on the new wider ME curves and will run much better too. This will probably be the first part of our layouts to be converted to the new rails. Cale (13 years ago, 4-Apr-11, to lugnet.trains, FTX)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) use a clumsy straight-curve-straight configuration for our corners; are the numbers on what those geometries are public information yet? We look forward to the Good News;-) JOHN (13 years ago, 3-Apr-11, to lugnet.trains, FTX)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) I'm not sure if I fully understand your question here, but I do have the additional geometry available for use in track draw, meaning, I should be able to convert it to BlueBrick (but I haven't played with it much). (...) I should be able to (...) (13 years ago, 3-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) when using CAD based track designers like Bluebrick? The full, half and quarter lengths of both the straight and curved tracks? Does the future also include renditions of the switches are crossings? (13 years ago, 3-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) I have a sample and the edges, while crisp rather than rounded, are not sharp enough to cut. There may be a bit more wear due to the metal corner, not sure. But I'm not too worried about that. The adapter piece is a little less shiny than (...) (13 years ago, 2-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) Our manufacturer of the rails runs the rail through a "de-burrer" machine. Basically there is a wash and bunch of ceramic stones. The unit vibrates and a unique smooth finish comes about when each rail comes out of the bath. There are no sharp (...) (13 years ago, 1-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) make this announcement... Neat system, but I have a concern that the plastic wheels against the sharp inside edge of the rail will wear down the wheels faster than usual. If I buy some, I might have to round off the top of the rails just a (...) (13 years ago, 1-Apr-11, to lugnet.trains)
|
