|
|
 | | One week left - more pics from BayLTC Pleasanton Show
|
| Since June 12, the Bay Area LEGO Train Club (BayLTC) has had a layout on display at the Amador-Livermore Valley Historical Society and Museum in Pleasanton, California. There is one week left until we take it down next weekend on July 11. This (...) (20 years ago, 5-Jul-04, to lugnet.announce, lugnet.trains, lugnet.org.us.baylug, lugnet.loc.us.ca.sf, FTX)
| | | | | Re: 8 wide help needed
|
| (...) I custom build my baseplates using regular plate, 3 layers thick with 2x4 technic plates built in to accept the bogie pin. I place the technic plate length wise on one layer and sideways on the other. I find the 6x train bases too resticting (...) (20 years ago, 5-Jul-04, to lugnet.trains)
| | | | | Re: 8 wide help needed
|
| (...) For short trucks with four wheels I use a standard 6x24 baseplate with 2xn plates along the edges (see brakevans from the link below) and make the single pairs of wheels rotate a bit with small belts to pull them back to straight. This is (...) (20 years ago, 4-Jul-04, to lugnet.trains)
| | | | | RichLUG and HardLUG to Display at GATS - July 17 & 18
|
| The Richmond Lego Users Group (RichLUG) and Hampton Roads Lego Users Group (HardLUG) will present a join display at the GATS show in Richmond, Virginia, on July 17 and 18. The Showplace exhibition center, located at 3000 Mechanicsville Turnpike) (...) (20 years ago, 4-Jul-04, to lugnet.org.us.richlug, lugnet.trains.org)
| | | | | Re: 8 wide help needed
|
| (...) Hello Adam , There are a few ways ,it can be done! If you are building no longer than 28 studs. Then use a 6 wide train base and put 2 wide plates on the edges of it. That would be the easiest way. I have used a 6 wide train base in my 8 wide (...) (20 years ago, 4-Jul-04, to lugnet.trains)
|
|
