 | | Re: MOC 36 Axle Schnabel Car
|
|
(...) Maybe its time to switch to a curve, straight, curve, straight, corner design? Josh (21 years ago, 26-Nov-03, to lugnet.trains)
|
| |
| | Re: DCC chip installed in accessory brick
|
|
In lugnet.trains, David Koudys wrote: <snip> (...) Oh My Goodness!!! THis could get really fun! So I install the Lenz N decoder in a train motor, leaving the 2x2 contact plate alone (still connected to the wheel pickups) Just soldered the pickups to (...) (21 years ago, 26-Nov-03, to lugnet.trains)
|
| |
| | Re: DCC chip installed in accessory brick
|
|
(...) I was thinking exactly this type of scenario at work today--getting a train motor and taking out the motor--just use the contacts--but then I figured that maybe I'll adapt one of my motors so that the 2x2 electric plate stays directly (...) (21 years ago, 26-Nov-03, to lugnet.trains)
|
| |
| | Re: DCC chip installed in accessory brick
|
|
This is great! Don't forget that this device does not have to be stationery but could be incorporated into your mobile wrecker crane for remote control of those tricky salvage operations! You will need some method of picking up the contact to the (...) (21 years ago, 25-Nov-03, to lugnet.trains)
|
| |
| | Re: DCC chip installed in accessory brick
|
|
(...) Dave, I don't know if you already did this, but before you glue it together, consider putting diodes in parallel with the light outputs. This will allow you to run inductive loads like motors and relays with the light outputs without fear of (...) (21 years ago, 25-Nov-03, to lugnet.trains)
|
