To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 9262
9261  |  9263
Subject: 
Re: Centrifugal clutch?
Newsgroups: 
lugnet.technic
Date: 
Fri, 14 Feb 2003 12:22:52 GMT
Viewed: 
1323 times
  
In lugnet.technic, Paul Kleniewski writes:
you are right tobbe but without lubrication it will probably not working
cause of force which will work on the weel you talked
caouse ther will no balance :(((

I'm not sure I follow your English this time pixel?

Sure there will be some friction on the pin that the 6641 slide on, but I don't
think it will be greater then the centrifugal force. A rubber band that
retracts the 6641's is also needed. I don't think lube is necessary, it will
probably smooth things a tad but it should do without it.

Regarding balance the spinning center needs to be made in at least two
identical setups, one on each side of the axle. Perhaps three can be made to
get greater clutch power against the inner side of the rim.

One problem might be if the inner rim is not round but more eliptical but it
should work with TLC's quality.

Of course, finding a use for this application would be hard since the whole
thing will be pretty big and the clutch power weak.

/Tobbe



Message has 2 Replies:
  Re: Centrifugal clutch?
 
"Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message news:HAAt24.BJz@lugnet.com... (...) i'm sure you do :))))) (...) don't (...) will (...) sometimes when i move the gear stick along the axle it has a lot of friction (some axles are thinner than (...) (22 years ago, 14-Feb-03, to lugnet.technic)
  Re: Centrifugal clutch?
 
look here deep link (URL) moderation (URL) (22 years ago, 14-Feb-03, to lugnet.technic)

Message is in Reply To:
  Re: Centrifugal clutch?
 
you are right tobbe but without lubrication it will probably not working cause of force which will work on the weel you talked caouse ther will no balance :((( but the idea is good pixel "Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message (...) (22 years ago, 14-Feb-03, to lugnet.technic)

14 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR