Subject:
|
Re: Beef about LEGO motors (rant)
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sat, 26 Oct 2002 21:48:03 GMT
|
Viewed:
|
1670 times
|
| |
|
|
As an afterthought... Lego must have realized the problem
because the Microscout, Manas motor unit, and Spybots ALL
use an axle socket for motor output! With the recent revision
of the 9V motors, it would have been nice if they could have
incorporated this into the design.
Mark
|
|
Message has 1 Reply:
 | | Re: Beef about LEGO motors (rant)
|
| "Mark Riley" <markril@hotmail.com> wrote in message news:H4LzAu.965@lugnet.com... (...) have a look that all of thise units are much bigger than technic motor so I think that lego has to think about positioning and bearing the axle notice that (...) (22 years ago, 28-Oct-02, to lugnet.technic)
|
Message is in Reply To:
| | Re: Beef about LEGO motors (rant)
|
| No, it's not just you... I've found myself many times in the same predicament, and just like you, end up doing something less compact to get around the problem. I haven't peeked inside one of the motors, but I suspect there's probably not a lot of (...) (22 years ago, 26-Oct-02, to lugnet.technic)
|
11 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
