Subject:
|
8735 set with too many parts?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sun, 22 Sep 2002 19:56:06 GMT
|
Viewed:
|
693 times
|
| |
|
|
Look at this picture:
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=247729
Look at photo on backside of the instructionbook (upper right corner of
picture).
Arent there TOO many parts in this set?
All the pieces on the table is from the newly bought set. There are 5
Techinc Pin 3/4 (partnr 32002) but the instruction says it should be only 4.
There ar 3 Technic Bush (partnr 3713) and 3 Technic Bush 1/2 Smooth (partnr
4265C) and there should be only 2 of each. And there are 3 Technic Gear 8
Tooth and at the instruction photo there are only 2.
The rest is in correct numbers.
What is the correct number of pieces in this set?
Another thing is that this is probably an verry old set I found way back on
the shelf in the shop, and it was about 249NOK (about US$33) but the new
ones cost 299NOK. But the set was the same, just a diffrent print on the
box.
Lek Vel
Øyvind Steinnes
http://www.brickshelf.com/cgi-bin/gallery.cgi?m=Phoenix
|
|
Message has 2 Replies:
 | | Re: 8735 set with too many parts?
|
| Hello It is quite normal to have some parts extra in Technic sets. In the 8735 set which I bought there were also these same extra parts. Greetings from the Netherlands Maico Arts "Øyvind Steinnes" <senniets@online.no> schreef in bericht (...) (22 years ago, 22-Sep-02, to lugnet.technic)
| | | Re: 8735 set with too many parts?
|
| (...) Øyvind, It is not unusual for LEGO to include extra numbers of small parts, including bushes, pins and 8 tooth gears (also 1x1 round plates etc in non-technic sets). I assume this is because the machines are less accurate counting the smaller (...) (22 years ago, 22-Sep-02, to lugnet.technic)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
