Subject:
|
Re: 8735 set with too many parts?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sun, 22 Sep 2002 23:04:18 GMT
|
Viewed:
|
886 times
|
| |
|
|
In lugnet.technic, Øyvind Steinnes writes:
> Look at this picture:
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=247729
>
> Look at photo on backside of the instructionbook (upper right corner of
> picture).
>
> Arent there TOO many parts in this set?
> All the pieces on the table is from the newly bought set. There are 5
> Techinc Pin 3/4 (partnr 32002) but the instruction says it should be only 4.
> There ar 3 Technic Bush (partnr 3713) and 3 Technic Bush 1/2 Smooth (partnr
> 4265C) and there should be only 2 of each. And there are 3 Technic Gear 8
> Tooth and at the instruction photo there are only 2.
> The rest is in correct numbers.
> What is the correct number of pieces in this set?
Øyvind,
It is not unusual for LEGO to include extra numbers of small parts,
including bushes, pins and 8 tooth gears (also 1x1 round plates etc in
non-technic sets).
I assume this is because the machines are less accurate counting the smaller
parts, and they'd rather include 1 extra than have lots of people calling
them up with pieces missing. But I could be wrong.
ROSCO
|
|
Message has 3 Replies:
 | | Re: 8735 set with too many parts?
|
| i think that it is actually cheaper for lego to make the machines that put the parts in the bag err on the side of extra than be 100% accurate and make an occaisional error of too few parts. -tk "Ross Crawford" <rcrawford@csi.com> wrote in message (...) (22 years ago, 23-Sep-02, to lugnet.technic)
| | | Re: 8735 set with too many parts?
|
| (...) Actually, come to think of it, I cannot really remember ever buying a Technic set that did not contain a couple of extra small bits. In pneumatic sets it is also common to have an extra T-connector and additional tubing left over. Once in a (...) (22 years ago, 26-Sep-02, to lugnet.technic)
| | | Re: 8735 set with too many parts?
|
| (...) 1x1 round plates, short technic pins, bushings, helmet visors, and 8 tooth gears always, ALWAYS come with 1 extra in every set. Without fail. I think it's because they're tiny pieces and are easily lost, so they throw in one extra just for (...) (22 years ago, 26-Sep-02, to lugnet.technic)
|
Message is in Reply To:
| | 8735 set with too many parts?
|
| Look at this picture: (URL) at photo on backside of the instructionbook (upper right corner of picture). Arent there TOO many parts in this set? All the pieces on the table is from the newly bought set. There are 5 Techinc Pin 3/4 (partnr 32002) but (...) (22 years ago, 22-Sep-02, to lugnet.technic)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
