 | | Re: New Parts —John Barnes
|
| | | :) How thick would the center section need to be - one plate (1/3 brick)? Zero is hard - it'd be just a handful of little double length studs ;) So assuming you want some plate thinckness pieces, what size and color and how many do you need? JB (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
| | | |
| | | | | RE: New Parts —Ralph Hempel
|
| | | | | A quick hack might be to just glue the exisiting plate parts back to back. That gets you a two-plate stud reverser. The other route is to eliminate the ridge at the bottom of the two plates before you glue them together. I THINK this leaves enough (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: New Parts —Larry Pieniazek
|
| | | | | | (...) Glue?? Ewwww.... (...) Not that there's anything WRONG with that! I THOUGHT I saw milling machine marks. :-) John, you should have posted something about some obscure set you found with these nifty new parts in them (after brassoing the marks (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
| | | | | | |
| | | | | | | | Re: New Parts —John Barnes
|
| | | | | | :) (...) Yeah, I was going to try that, it's no coincidence that this is April 1 ;) But I didn't have time to polish them last night, and that darn digital camera takes much too detailed pictures! So I bailed on the whole "anyone know what set these (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
| | | | | | |
| | | | | RE: New Parts —William Howard
|
| | | | | An "inverted tile" please - ie one with studs on the top and filled in on the bottom (so I can add "skid pans" to the bottom of vehicles. Black and dark grey (at least but I can also think of reasons for all the other colours that standard tiles (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: New Parts —Ross Crawford
|
| | | | | | (...) How about (URL) (23 years ago, 3-Apr-02, to lugnet.technic)
|
| | | | | | |
| | | | | | | | RE: New Parts —William Howard
|
| | | | | | (...) robots when I can't be bothered to put in idler wheels - would be better though if you could get some that were flat (and different sizes) not domed, as you can't make nice large areas by abutting them. (23 years ago, 3-Apr-02, to lugnet.technic)
|
| | | | | | |
| | | | | Re: New Parts —Larry Pieniazek
|
| | | | (...) Actually not a bad idea! The (misnamed in my view) light grey "technic 1 1/2 pin" *almost* fills the bill, it almost fits inside a brick bottom, except for it's shoulder But plate thickness is fine. That's what THEY did in theirs. (...) Size? (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
| | | | |
