Subject:
|
Re: Joining Beams Axially at 90 deg
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 5 Dec 2001 20:34:46 GMT
|
Viewed:
|
1250 times
|
| |
|
|
In lugnet.technic, Thomas Avery writes:
> In lugnet.technic, Steven Lane writes:
> > That's exactly what I did, Axial... axis, sounds the same,
> > so I guessed that, was what it was.
> >
> > Steve
>
> I've put together a little information on basic engineering terms:
> http://www.texbrick.com/quick_pics/eng_terms.html
>
> This is the stuff you learn in a statics course, as Bram noted.
>
> TJ
Well my further education centered on computing, not the mechanical
science's, and I knew what torsion and bending we're before hand. I bet a
lot of technic readers didn't know what axial strenght was either.
Steve
|
|
Message has 1 Reply:
 | | Re: Joining Beams Axially at 90 deg
|
| (...) You're right! I don't know what "axial strenght" is either. But I do know what "axial strength" is ;-) There are two ways to load a member axially: tension and compression (i.e. pulling and squashing). I had been talking about axial tension, (...) (23 years ago, 5-Dec-01, to lugnet.technic)
|
Message is in Reply To:
21 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
