Subject:
|
Re: Technic "Ball and Axle" part question.
|
Newsgroups:
|
lugnet.general, lugnet.technic
|
Date:
|
Sat, 5 May 2001 23:02:13 GMT
|
Viewed:
|
205 times
|
| |
|
|
In lugnet.general, Thomas Avery writes:
> Check out set numbers 8500, 8503, & 8505 (or any of the sets in the
> Throwbot/Slizer section) on the Lugnet set reference. Many of the sets
> contain the part in question. Look at the ankle joint of the 2-legged
> Throwbot/Slizer-whatever-they-are.
>
> This is the same part used in the Stormtrooper.
>
>
> The axle hole in the ball is 1 stud deep. So when a 2 stud long axle is
> inserted, 1 stud length sticks out.
>
> T. J.
Thanks T.J. now I know the different lengths to cut my axles. I stated this
thread to get info about the “Ball/w axle-hole” I have several of the socket
pieces to which you refer, I think they come in every throwbot set.
Thanks for the help.
Jay
|
|
Message is in Reply To:
 | | Re: Technic "Ball and Axle" part question.
|
| (...) Check out set numbers 8500, 8503, & 8505 (or any of the sets in the Throwbot/Slizer section) on the Lugnet set reference. Many of the sets contain the part in question. Look at the ankle joint of the 2-legged Throwbot/Slizer-what...-they-are. (...) (24 years ago, 5-May-01, to lugnet.general, lugnet.technic)
|
16 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
