 | | New Hexapod
|
|
hello boys and girls this is a technic hexapod i actually finished a while ago but never got around to publishing. it runs on one motor and is no longer than a single technic beam. check it out and let me know what you think.... (URL) (25 years ago, 10-Aug-00, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Suspension
|
|
(...) I attached the wheels to the motor, and built most of the rear engine compartment, including exterior body and fiber-optic engine. The suspension is quite stiff. Thanks to a worm gear, the vehicle moves slowly but steadily. The fact that the (...) (25 years ago, 11-Aug-00, to lugnet.technic, lugnet.build)
|
| |
| | Re: code pilot program 8479 New??!!
|
|
(...) I found it shortly after getting me "Green truck" (What a wonderfull colour that is by the way) I was hoping that it would let me construct my own sequences, and the combine them into a single barcode, but nono, it simply prints all the codes (...) (25 years ago, 10-Aug-00, to lugnet.technic)
|
| |
| | Re: code pilot program 8479 New??!!
|
|
I've had it for at least a year. It could be older and there may be a newer version now. My complaints were that it was rather limited in the "length" of a program allowed, even though the CodePilot will store the bigger programs. And I believe the (...) (25 years ago, 10-Aug-00, to lugnet.technic)
|
| |
| | RE: Suspension
|
|
(...) I hope it works :) I've built two wheels with suspension now, so I'll try to get it motorized and then add the rest of the frame, the articulation, and the other wheels. (...) I'm not ;) Instead I built a somewhat similar system: basically two (...) (25 years ago, 10-Aug-00, to lugnet.technic, lugnet.build)
|
| |
| | Re: Suspension
|
|
(...) browser. Just some notes and the LEGO webring on the bottom. (...) This sounds just like the suspension I'm working on at the moment! It's a very interesting approach. Fredrik (25 years ago, 10-Aug-00, to lugnet.technic, lugnet.build)
|
| |
| | Re: Suspension
|
|
(...) That sounds fun! I expect that we will see LDraw'n images shortly... ;-) (...) But how are you going to connect your custom wheels to the 8880 suspension? It only supports the native 8880 wheels, unfortunately. (...) Yep, that works quite (...) (25 years ago, 10-Aug-00, to lugnet.technic, lugnet.build)
|
| |
| | code pilot program 8479 New??!!
|
|
Hey, I just found the downloadable code pilot program from lego to write programs for the 8479...has anyone used this? is it new? I haven't heard of it before.... (25 years ago, 10-Aug-00, to lugnet.technic)
|
| |
| | RE: Suspension
|
|
(...) --Bram Bram Lambrecht BXL34@po.cwru.edu (URL) (25 years ago, 10-Aug-00, to lugnet.technic, lugnet.build)
|
| |
| | RE: Suspension
|
|
(...) No, but almost as round as an LDraw cylinder :) It's 12 sided, built with a ring of <part: 4590> 1x4 offset plates. It's about 6 studs wide where it's in contact with the ground and 8 studs in the center. I expect it'll work best on carpet. (...) (25 years ago, 10-Aug-00, to lugnet.technic, lugnet.build)
|
