To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 1666
1665  |  1667
Subject: 
Re: Another pneumatic compressor and pressure switch designs
Newsgroups: 
lugnet.build, lugnet.robotics, lugnet.technic
Date: 
Thu, 22 Jun 2000 13:15:27 GMT
Viewed: 
214 times
  
Michael Tomlinson wrote:

I've seen lots of designs but none have enough power, air-wise.  I need
pressure and volume!  I made a good one once using two of the large spring
loaded pumps.  But that was using really old technic motors.... the
mindstorms motors are much to weak to power that design.  Besides, it was
huge :-(
The little cylinders make such a tiny amount of air, they're no use at all!
Does anyone have plans for a usable air source?
I've used two of the little pumps in conjunction with two Air Tanks. I
takes 15-20 sec. to fill up the tanks and afterwards you can operate a
pneumatic cylinder every 2.5 - 3 sec. for about 15 min. while the
compressor is running coutinously.

The pumps where driven by an old 9V technics motor which directly drives
a wormgear.

Regards
Carsten



Message is in Reply To:
  Re: Another pneumatic compressor and pressure switch designs
 
I've seen lots of designs but none have enough power, air-wise. I need pressure and volume! I made a good one once using two of the large spring loaded pumps. But that was using really old technic motors.... the mindstorms motors are much to weak to (...) (24 years ago, 22-Jun-00, to lugnet.build, lugnet.robotics, lugnet.technic)

9 Messages in This Thread:







Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR