| |
I have built another pneumatic compressor and
pressure switch; I believe both are improvements
on the previous designs. The compressor is
full-stroke, double-pump, uses the new 9v motor
and is rather small; the pressure switch is
similar to Ralph Hempel's one but is more
compact. Both compressor and switch designs
adhere to exact LEGO geometry, so I expect
them to perform well in real models.
http://www.malgil.com/esl/lego/pneumatics.html
Any comments/suggestions/test results are
appreciated...
Regards,
Sergei Egorov
Reply to: esl at acm.org
|
|
Message has 5 Replies:
 | | USB IR tower?
|
| Does anybody know if a USB version of the Mindstorms' IR tower has been seriously considered, and/or if one would happen to be in the works? One would normally use a USB-serial converter if stuck using only USB, but I'm also stuck in an environment (...) (24 years ago, 3-Jul-00, to lugnet.robotics)
| | | Re: USB IR tower?
|
| (...) I'm almost certain that the upcoming RCX 2.0 's IR-Tower is USB. (...) A RF comms would be even nicer, like my Cybermaster :) The only advantage of a USB-PBrick instead of a RF-PBrick(+IR to inter-PBrick comms) would be that the PBrick could (...) (24 years ago, 4-Jul-00, to lugnet.robotics)
|
9 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
