Subject:
|
Re: Two New GBC Modules..
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 15 Aug 2007 14:54:48 GMT
|
Viewed:
|
9583 times
|
| |
|
|
I built it last night. My earlier problem was in trying to use 4-stud axles to
hold the pulleys in their offset position -- this is hard to describe, but the
gist of it is the axles sometimes got in the way of other pulleys and warped
their position. This time I started with every pulley on a single 12-stud axle
(not using the center hole), and then I used 2-stud axles between every pulley
to make the offset.
|
|
Message is in Reply To:
 | | Re: Two New GBC Modules..
|
| (...) It's hard to tell from that picture, but pause the video and you'll see the balls run up at a 6-stud spacing. That means the peaks of the wave are six studs apart. The cams are spaced with one pulley plus a half bush, so are spaced exactly one (...) (17 years ago, 14-Aug-07, to lugnet.technic, FTX)
|
10 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
