|
|
 | | Re: Technic prop
|
| (...) Hi Steve, First I tried measuring its radius but this is not an easy task as the center point and the tip of the blades are on different planes. It looked like slightly less than 60mm but I could not tell for sure. So I built the test rig (...) (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Technic prop
|
| (...) Did you actually measure it or is that a guestimate? cause I need an accurate figure. Thanks Steve (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Technic prop
|
| (...) blade length to center of prop appears to be about 60mm/2.5" hope that helps (19 years ago, 22-Dec-05, to lugnet.technic)
| | | | | Re: Worm Gear Problem
|
| (...) Hi Eric, I actually intended that the inherent backlash in the z16s was exploited to turn them in a little after the positioning. You could replace my z16s with two z24s and a z8, making one of the z24s a clutch gear so you could turn them (...) (19 years ago, 22-Dec-05, to lugnet.build.mecha, lugnet.technic)
| | | | | Re: Worm Gear Problem
|
| Hey Danny, thats interesting. You may be on to something. I'm wondering, when a corrective tension is added (turning the opposing gear) the center of the axle will twist. Also, because the two drives are linked with z16's, when you turn one, the (...) (19 years ago, 22-Dec-05, to lugnet.build.mecha, lugnet.technic)
| | | | | Technic prop
|
| Can someone who has this part (URL) measure the radius described by the rotation of the blades and let me know what it is. Thanks Steve (19 years ago, 21-Dec-05, to lugnet.technic)
| | | | | Re: Millenia Car
|
| (...) Yeah, it's a shame about the driver's steering. Unfortunately, and I'm sure this is a common problem, it's a simple case of insufficient room. The block holding the dashboard side of the engine actually forms part of the dashboard, which (...) (19 years ago, 21-Dec-05, to lugnet.technic)
| | | | | Re: Millenia Car
|
| Replies are in text.. (...) Don't worry about it - this is great stuff. (...) I also had that set. I didn't think the plane was so bad- great for part harvesting. I have already thrown the plane kit parts into my general pool of Lego, but I have (...) (19 years ago, 21-Dec-05, to lugnet.technic)
| | | | | Millenia Car
|
| My ever first post here guys, so bear with me... This is my first SERIOUS attempt at a MOC... built primarily out of parts from last year's plane set (can't remember the set no. - it's the one with tilting wings and popout landing gear). (URL) (...) (19 years ago, 21-Dec-05, to lugnet.technic)
| | | | | Re: Change of email address
|
| (...) Merry C for you 2 too ;) (...) Try (URL) though it may not be approved immediately. ROSCO (19 years ago, 19-Dec-05, to lugnet.robotics, lugnet.technic)
|
|
