Subject:
|
Pneumatic steering
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 12 May 2005 14:45:55 GMT
|
Viewed:
|
3263 times
|
| |
|
|
How do you people set it up? Do you use those small pneumatic pistons for the
steering? If not, then what? How is the system operated? Do you use a
gear-operated valve? Do you have any LDraw designs that you could show me?
(Sorry for the redundancy of this question)
|
|
Message has 2 Replies:
 | | Re: Pneumatic steering
|
| (...) Up to now I've just moved the two levers of the input valves. My system uses 2 large cylinders facing each other. The steering arm moves 3 valves, which are offset from each other and two of which are pulled by rubber bands. Sorry I haven't (...) (20 years ago, 12-May-05, to lugnet.technic)
| | | Re: Pneumatic steering
|
| (...) Hi Vineet, Here is one way to do it: (URL) prototype was built when I was thinking of building an articulated truck. The same principle can be applied to any kind of steering where you need three positions. The key element is the controller: (...) (20 years ago, 12-May-05, to lugnet.technic)
|
Message is in Reply To:
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
