To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 11836
  Gearbox 8860 trouble
 
Hi, I´m having a slight problem building the gearbox on the 8860... How many gears is it supposed to have? It is technically able to have 3, but if you follow the instructions its impossible to use more than 2. Check this scan of page 16 out and (...) (21 years ago, 27-Dec-03, to lugnet.technic)
 
  Re: Gearbox 8860 trouble
 
(...) remove the 2x4 plate, then use whatever blue plates so that the stick shift can be in 3 separate positions I built this car with 3 gears many years ago... that's how I did it (iirc ;) ) Dave K (21 years ago, 27-Dec-03, to lugnet.technic)
 
  Re: Gearbox 8860 trouble
 
(...) Waking up more and actually running off to find the instructions and looking at 'em... Step 17--don't put the 2x3 plate in, instead, use a 2x2 plate and don't cover up the third space for the stick shift... Rest of the steps are fine. Hope (...) (21 years ago, 27-Dec-03, to lugnet.technic)
 
  Re: Gearbox 8860 trouble
 
(...) I remember this too, Christmas of 1980 I think it was. Serious nostalgia here! I think the reason for the cover was that the engine fairly rattles along when you push the car in the lowest gear, which is fine as long as you have built the (...) (21 years ago, 28-Dec-03, to lugnet.technic)
 
  Re: Gearbox 8860 trouble
 
"Jennifer Clark" <jen@vulture.dmem.strath.ac.uk> schreef in bericht news:HqLGzx.235n@lugnet.com... (...) (iirc ;) ) (...) here! I (...) when you (...) the (...) to (...) It sure did! (...) when (...) gearbox (...) Check the building instructions... (...) (21 years ago, 28-Dec-03, to lugnet.technic)
 
  Re: Gearbox 8860 trouble
 
snip > (...) shift can (...) (iirc ;) ) (...) looking at (...) cover up (...) It sure do, thank you. I suspected that I had to use my brain instead of following the instructions. ;-) When I build sets I´m a Lego-purist and want to build exactly as (...) (21 years ago, 29-Dec-03, to lugnet.technic)
 
  Re: Gearbox 8860 trouble
 
(...) Hi Joakim, The actual gearbox does have 3 gears, but according to the instructions it only uses 2 at a time. The reason for this I think is: Without the motor, 1st gear causes the engine to rotate too quickly, and can cause damage to axles. I (...) (21 years ago, 2-Jan-04, to lugnet.technic, FTX)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR