 | | 8860 Scissors lift
|
|
Hi all, I noticed that the box for the <set:8860> car chassis has a scissors lift. The scans of the instructions on brickshelf: (URL) do not have any instructions for the scisssors lift. Was there a second book in the box or was this just a (...) (25 years ago, 16-May-01, to lugnet.technic)
|
| |
| | Re: Spring/elastic wind-up engine
|
|
(...) For a simple rubber-band-driven biped, check out (URL) you can transalate from japanese into English at (URL) is one of the many Lego Bipeds on my list at (URL) (25 years ago, 16-May-01, to lugnet.technic)
|
| |
| | Re: Spring/elastic wind-up engine
|
|
(...) I once made a car with a technic liftarm 1 x 3 attached to a cross-axle and some gears to the back wheels. (URL) attached the rubber bands in another part of the chassis and lay them over the technic liftarm and then wound up the engine by (...) (25 years ago, 16-May-01, to lugnet.technic)
|
| |
| | Re: RFC:LoTek updated with a RC Killough and videos of the Lynx tank
|
|
(...) Yeah, I try to make them move as fast as possible w/o comprimising to much raw power. It's more fun to drive a fast model with radio control you see. All movies are 100% speed except the slow motion shot on the Lynx page ,) (...) (...) (25 years ago, 16-May-01, to lugnet.technic)
|
| |
| | Re: RFC:LoTek updated with a RC Killough and videos of the Lynx tank
|
|
(...) Yes, I'm pretty happy with the quality, especially since I'm customed to use my video camera to capture "photos". I bought a more expensive camera since I do a lot of photographing in the nature and such while biking/walking. I bought a Kodak (...) (25 years ago, 16-May-01, to lugnet.technic)
|
