 | | Re: How do I mount a motor in a studless construction?
|
|
(...) Another option is this part: (URL) matches the geometry of the modified plate with pin hole that you proposed using for the bottom rather well. There *is* a mate for this BTW: (URL) I find I use the modified 2x2 plate more often, as it's (...) (19 years ago, 27-Dec-05, to lugnet.technic)
|
| |
| | Re: How do I mount a motor in a studless construction?
|
|
(...) How about putting these on top: (URL) the motor studs in the holes? for 71427 or 43362 use two each side, leaving the 9V connector free. A 2838 motor could have 5 each side. Try these on the bottom: (URL) some plates on the motor to make the (...) (19 years ago, 27-Dec-05, to lugnet.technic)
|
| |
| | How do I mount a motor in a studless construction?
|
|
I'm looking for some ways of mounting a motor in a good solid mostly studless construction that doesn't need lots of fiddling around with. I'm looking to mount both 43362/71427 and 2838 styles of motors, but I've no idea how to make it a fairly (...) (19 years ago, 27-Dec-05, to lugnet.technic)
|
| |
| | Re: Progetto Formula 1 Technic
|
|
(...) Hi Mark, I can do it, but obviously it will be a resume! My latest V10 F1 car is online: next one will be from 2006 season, with a V8 engine... (URL) I'm going to check the possibility to model some "old" historic F1 car... it depends on (...) (19 years ago, 26-Dec-05, to lugnet.org.it.itlug, lugnet.technic)
|
| |
| | Re: Progetto Formula 1 Technic
|
|
(...) It's basically spanish with a lot of letter 'i's (19 years ago, 25-Dec-05, to lugnet.org.it.itlug, lugnet.technic)
|
