 | | Re: Connecting New Cylinders
|
|
(...) Thanks Philo for the ideas, I find them very useful. (21 years ago, 13-Dec-03, to lugnet.technic, FTX)
|
| |
| | Re: Connecting New Cylinders
|
|
Thanks Kevin for the ideas. (21 years ago, 13-Dec-03, to lugnet.technic)
|
| |
| | Re: Connecting New Cylinders
|
|
(...) It works very well! (URL) Philo (21 years ago, 12-Dec-03, to lugnet.technic, FTX)
|
| |
| | Re: JCB JS220 Excavator
|
|
(...) I keep most of them built up these days, you are right, it is definitely hard to take these apart, they take months to build... Really the only time I think about taking a model apart is when it is superceded by a better one. Jennifer (21 years ago, 12-Dec-03, to lugnet.technic)
|
| |
| | Re: Connecting New Cylinders
|
|
(...) Well, I don't have any of the new pistons so this may not work, but have a look at this setup (click for larger view): (URL) With the new pistons, you should be able to use the new 1x2 liftarms instead. To get the liftarm to seat properly over (...) (21 years ago, 12-Dec-03, to lugnet.technic, FTX)
|
| |
| | My first swiled LEGO
|
|
I called LEGO the other day about a piston that had a broken off pressure port, and got a replacement. The replacement piston has swirls of a darker colored plastic in the yellow cylinder part as can be seen here in the right piston. (URL) not aware (...) (21 years ago, 12-Dec-03, to lugnet.technic)
|
| |
| | Re: Connecting New Cylinders
|
|
(...) Hi Jonathan, Here is a second version. The gaps between two back to back are not nice integral stud lengths. This makes it a pain. It turns out that the larger of the two gaps is the pretty close to the distance between the outer edges of (...) (21 years ago, 12-Dec-03, to lugnet.technic)
|
| |
| | Re: Connecting New Cylinders
|
|
(...) Hi Jonathan, I'd never tried this, but was able to come up with this: (URL) problem with it is that the pistons are not in perfect alignment. (URL) (21 years ago, 12-Dec-03, to lugnet.technic)
|
| |
| | Re: JCB JS220 Excavator
|
|
(...) A comment on how you might be able to control the speed of pneumatics is to add an orifice to both of the line of the cylinder. This would regulate the amount and speed of the air entering and leaving the cylinder. Hope this gives you some (...) (21 years ago, 12-Dec-03, to lugnet.technic)
|
| |
| | Connecting New Cylinders
|
|
Hello I am trying to connect two of the new form factor cylinders back-to-back. Does any one have any ideas? I wish only to use lego parts. Thanks (21 years ago, 12-Dec-03, to lugnet.technic)
|
