 | | Re: Question about set 8094
|
|
Jonathan Wilson's utterance expressed in news:HD6HJ9.15w7@lugnet.com: (...) I don't own it, but am almost sure it is a felt-tip pen. It has to be able to glide easily over the paper. Ball- points has a tendency to "scratch" the paper when held (...) (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Re: Heavily modified 8880 chassis, succesfully motorised and solar powered.
|
|
(...) An image says more than a thousand words :D (URL) this above image you see the part of the car the motor is strapped to. On top of the 2 yellow 8x1 plates rests the motor, with the 16 tooth gear on its axle. The rubber band around the motor (...) (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Question about set 8094
|
|
1.what type of pen is the technic pen included in the set? (ball-point, felt tip, etc) and 2.what type and size is the paper? A4? (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Re: Flex System question
|
|
(...) pneumatics etc. Best regards, /Tobbe (URL) SPAM when e-mailing) (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Re: Question about the technic action figure diving accessories
|
|
(...) You can probably work out a pretty good length by looking at this: (URL) the curve about the same as in the instructions and you should be fine. Sure it won't be down to mm but does it matter? Best regards, /Tobbe (URL) SPAM when e-mailing) (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Re: Flex System question
|
|
(...) Well I used them for hydraulic rams 8?) (URL) (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Question about the technic action figure diving accessories
|
|
Can anyone tell me what sort of hose and what length of hose should be used for the air-hose that goes with these accessories? (21 years ago, 11-Apr-03, to lugnet.technic)
|
| |
| | Re: Heavily modified 8880 chassis, succesfully motorised and solar powered.
|
|
(...) How difficult was it to ensure that the motor was straight, level, and the gears meshed properly? It seems like a lot of work, but it really paid off! How did you do it? :) I love the speed of it in the movie. How fast do you estimate it was (...) (21 years ago, 10-Apr-03, to lugnet.technic)
|
| |
| | Re: bionicle masks
|
|
(...) www.brickbay.com or www.ebay.com Those are where i would go. Tukua (21 years ago, 10-Apr-03, to lugnet.technic.bionicle)
|
| |
| | Re: 60c01 24 tooth clutch gear question.
|
|
(...) You can do the same thing with a differential, and it is much more efficient. Put ratchets on the output of the diff. One output drives the compressor, and the other drives the switch. You will have to connect the switch to a crank so its (...) (21 years ago, 10-Apr-03, to lugnet.technic)
|
