 | | Re: Power Pullin' With My Tractor
|
|
(...) Hey, very informative page! I see now I didn't brake 12tooth gears, but 14tooth bevel gears. (4143) These look even flimsier than the current 12 tooth bevel gears... About the 24t gears, I'm currently using them like this: (URL) the 2 24t (...) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | Re: New MOC supercars
|
|
(...) Unfortunately I don't have the Williams F1, so I don't know if the silver panels can be replaced with the white and blue panels. Of course for every problem is a solution so probably with some little adjustments the blue and white panels can (...) (22 years ago, 10-Mar-03, to lugnet.technic, lugnet.loc.au)
|
| |
| | Re: MOC: Articulated Boom
|
|
"Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message news:HBJ9u6.6zo@lugnet.com... (...) this problem appears in both cases with opened valve and with closed too i think the problem is placed in big volume of pneumatic instalation cause when i (...) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | Re: MOC: Articulated Boom
|
|
<<snipp> (...) I suppose you use switches to control the action and don't pump with an switch/valve open? It takes careful manouvering on the switch to control the small pistons under preassure. Generally it's better to extend the lever on the (...) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | MOC: Articulated Boom
|
|
hello this is beta version of articulated boom with telescopic arm in general this application is the improvment of my jack02 (URL) to jennifer's sugestion i added another joint (second) which is connected (in terms of opening) with the bottom (...) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | Re: 8448 super car inventory by box number
|
|
(...) (URL) emptied box-by-box and shot each occation with my video camera (hence the quality). The instructions manual should also help out, of course it wont show extra elements... Best regards, /Tobbe (URL) SPAM when e-mailing) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | Re: Power Pullin' With My Tractor
|
|
(...) You could double all the z24 gears and link then togheter with friction pins and/or cross axles. Or, you could boil them: (URL) don't blame me if it wont work with the old z24's and it will certainly ruin any warranty :) (...) See this (...) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | Re: Heavily modified 8880 chassis, succesfully motorised and solar powered.
|
|
hi i've tried to put this idea in life (? :) but the group members said it has been done alredy and sent me links to model team like (better) models but is i understand you well you mean the technic like model so i did the technic car seat which (...) (22 years ago, 10-Mar-03, to lugnet.technic)
|
| |
| | Re: New MOC supercars
|
|
(...) Hi. My first lugnet post for quite awhile, so delurk. I really would like an instruction book for "the car". It looks awesome! I can actually say that I am going to release my 2003 williams f1 car sometime this week, and If anyone wants (...) (22 years ago, 10-Mar-03, to lugnet.technic, lugnet.loc.au)
|
| |
| | New MOC supercars
|
|
Hi all, It was a big surprise that I recently found a topic with pictures of my work. (URL) I couldn't wait to give some reply. It seems that some people are interested in my work. Thanx for that!!:) The story is that once I started an instruction (...) (22 years ago, 9-Mar-03, to lugnet.technic)
|
| |
| | Re: Heavily modified 8880 chassis, succesfully motorised and solar powered.
|
|
Updated .ldr is ready, in case anyone cares... The (non-lego-) motor is located on the 2 yellow 1x8 plates over the rear axle. That 16tooth gear you see 'floating' in the air on the 24tooth gear is on the motor's axle. The motor is connected to the (...) (22 years ago, 9-Mar-03, to lugnet.technic)
|
| |
| | Re: Heavily modified 8880 chassis, succesfully motorised and solar powered.
|
|
(...) Nicely ambitious idea, but I don't nearly have enough lego to make it reality. Right now it's just a 8880 derived solar car for me. :) Today at about 16:00 the sun decided to come out a bit. There were still some very thin clouds, and the sun (...) (22 years ago, 9-Mar-03, to lugnet.technic)
|
| |
| | Re: Unknown Instruction Book
|
|
(...) Hi all, About a week ago it was a big surprise for me to find a topic that goes about my designs. Now I can finally reply on this topic. So this is my first writing here :) Both the car and the instruction book are mine, and yes they are not (...) (22 years ago, 9-Mar-03, to lugnet.technic)
|
| |
| | Re: 8448 super car inventory by box number
|
|
(...) Although I got it MISB, unfortunately didn't keep an inventory of each box when building it. However, I know the general modules built by each box, I hope it helps you: Box 1 - frame Box 2 - steering + front wheel assembly Box 3 - differential (...) (22 years ago, 9-Mar-03, to lugnet.technic)
|
| |
| | 8448 super car inventory by box number
|
|
Hello..I was wondering if any you had an inventory of the 8448 super car separated by box number? I got a used 8448 and would like to sort the pieces into their original boxes. If you have it, I would very much appreciate a copy. Thanks Ramy (22 years ago, 9-Mar-03, to lugnet.technic)
|
| |
| | Re: Power Pullin' With My Tractor
|
|
hey tj, have you broken any u-joints yet or is the fix with the plate holding up good? also what is the yellow chasis at the top of your load? is that your liehberr excavator? steve (22 years ago, 8-Mar-03, to lugnet.technic)
|
| |
| | Re: Power Pullin' With My Tractor
|
|
(...) I don't have any new style 24t gears. My newest lego set is the 8880 supercar from 1995, that has now been dusted off and mutated to serve as a school project. :) (...) New style 24t gears would be fine, as long as they're compatible with the (...) (22 years ago, 8-Mar-03, to lugnet.technic)
|
| |
| | Re: Power Pullin' With My Tractor
|
|
(...) Dude, this is old! :-) (...) That's been my experience too. Especially with the old-style 24 tooth gears. In fact, the axle support kinda warps as the axle rotates out. And then sometimes it just breaks. Just use the new style 24t gears. The (...) (22 years ago, 8-Mar-03, to lugnet.technic)
|
| |
| | Re: Power Pullin' With My Tractor
|
|
Sorry for digging up an old thread ;) In the solar car I'm building (see the 'heavily modified 8880 chassis' thread) I've so far broken 3 old style 24 tooth gears. (among some old style 12 tooth crown gears, but that's no surprise really...) The (...) (22 years ago, 8-Mar-03, to lugnet.technic)
|
| |
| | Re: Heavily modified 8880 chassis, succesfully motorised and solar powered.
|
|
(...) Thanks Tobbe and Pixel for bringing up those links. I knew of, and was actually referring to Jeff Jahr's transmission but, the pneumatic version by Markku Jaaskelainen is totaly new to me. I wish I knew how to make an umlaut on this computer (...) (22 years ago, 8-Mar-03, to lugnet.technic)
|
