Subject:
|
Re: Unfinished Dropship
|
Newsgroups:
|
lugnet.space
|
Date:
|
Sun, 18 Dec 2005 20:05:52 GMT
|
Viewed:
|
2801 times
|
| |
|
|
Hi Mladen,
--SNIP--
It’s a pity you didn’t have time to finish it since the model looks pretty damn
good as is and I’m sure would have looked great when done.
| |
Aside from the overall SNOT construction, I discovered an interesting
new use
for part 30535.
|
I like this trick a lot. I wonder if the skeleton arm could be used for other
SNOTwork...
Tim
|
|
Message has 1 Reply:
 | | Re: Unfinished Dropship
|
| (...) Thanks Tim! (...) Yeah, it has tons of other uses. You can fit a 1x1 cylinder onto one end and get a nice small joint out of it. This is useful for mecha construction and micro-fig work. This isn't the best example, but it's still something: (...) (19 years ago, 18-Dec-05, to lugnet.space, FTX)
|
Message is in Reply To:
| | Unfinished Dropship
|
| (URL) I started this MOC back in August and stopped working on it by early September due to school. Unfortunately, I lost interest in completing it, and have to disassemble it for a new project I am planning for the winter break. A few notes about (...) (19 years ago, 18-Dec-05, to lugnet.space, FTX) !
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
