To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.vcOpen lugnet.robotics.vc in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Vision Command / 172
171  |  173
Subject: 
Re: Running Vision Command on XP
Newsgroups: 
lugnet.robotics.vc
Date: 
Fri, 22 Mar 2002 03:13:18 GMT
Viewed: 
9718 times
  
Hi all,
      A little birdie over at consumer affairs told me a patch is in the
works!  I was also told that this set is being discontinued. I should know
more after a few more e-mail communications.
I haven't played with the software yet, is it even worth the fuss?
Chris



Message has 1 Reply:
  Re: Running Vision Command on XP
 
I recieved this info today, and sounds like good news to me. "I can answer the questions for this gentleman however I don't know if he'll be any less frustrated. We are working on a Vision Command patch so it can install and run on Windows XP (...) (22 years ago, 22-Mar-02, to lugnet.robotics.vc)

Message is in Reply To:
  Running Vision Command on XP
 
I think I found the key to my previous success at getting VCS to run on W2K/XP. This is the good news - The bad news is you need to get a copy of RIS 2.0 and run the VCS update utility on the RIS CD. I don't know if this update is available from (...) (22 years ago, 28-Jan-02, to lugnet.robotics.vc)

13 Messages in This Thread:







Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR