 | | Re: SetWatch() only accepts constants
|
|
(...) Sorry, the opcode requires constants - there's not much NQC can do (aside from generating an enormous switch statement). Dave (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: maximum current of outputs
|
|
In my layout, I used Train power supply for RCX to drive train, the max voltage is 9.7v. Zhengrong (...) (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Help needed for an NQC newbie
|
|
Thanks a lot. I added the while statement and it worked. As far as the value of the light sensor, I kept the value I had and it worked correctly. I will post pictures of the setup after the weekend and you will understand. Jude Thanks again for the (...) (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Help needed for an NQC newbie
|
|
Try this. I had to change the value of the light sensor and add a While (true) statement. task main() { SetSensor(SENSOR_3,S...ROTATION); ClearSensor(SENSOR_3); SetSensor(SENSOR_2,S...OR_LIGHT); SetPower(OUT_A,2); while (true) if (SENSOR_2<40) { (...) (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: SetWatch() is remembered?
|
|
(...) The Watch will reset to 0000 when you turn off device. It gets cleared on power up every time. You can, however, start and stop programs and keep the time. Dean -- -Dean Husby LUGNET Member #320 (23 years ago, 7-Aug-01, to lugnet.robotics.rcx.nqc)
|
