Subject:
|
Re: dll 'error deleting program' with briskOS-0.9.0
|
Newsgroups:
|
lugnet.robotics.rcx.legos
|
Date:
|
Thu, 25 Aug 2005 11:54:34 GMT
|
Viewed:
|
13147 times
|
| |
|
|
In lugnet.robotics.rcx.legos, Tom Poliquin wrote:
> In lugnet.robotics.rcx.legos, Igor Podolak wrote:
>
> > I work with a Linux 2.6 (Fedora Core 3).
>
> [snip]
> > The system was downloaded successfully to the RCX 2.0 brick with firmdl3
> > program. All ok up to this moment. But I COULD NOT load ANY program with the
> > dll utility! Each time I got an 'error deleting program' message.
>
> [snip]
> > the RCX does not respond
> > correctly or at all, e.g.[igor@localhost brickos-0.9.0]$ dll -p1 -v
> > demo/helloworld.lx
>
> Igor,
>
> I just got mine up and running this weekend under Debian
> (thanks to apt-get / Synaptic).
>
> Since you have already successfully loaded firmdl3
> this may not be relevant but I had to setup
> a legotower0 device.
>
> sudo mknod /dev/usb/legotower0 c 180 160
> sudo chmod 666 /dev/usb/legotower0
> export RCXTTY=/dev/usb/legotower0
> firmdl3 -f brickOS.srec
>
> I believe that RCXTTY must be set for dll to work properly
> export RCXTTY=/dev/usb/legotower0
> dll -p2 sound.lx
>
> Alternately you may use
> dll -p2 --tty=/dev/usb/legotower0
>
> Hope this helps,
>
> Tom
I am also encountering this same problem:
- I am working with a Linux 2.6 (Fedora Core 3).
- The system was downloaded successfully to the RCX 1.0 brick with firmdl3.
- But I COULD NOT load ANY program with the dll utility! Each time I got an
'error deleting program' message.
However I am using an RCX 1.0 and a serial tower - does anyone have any
suggestions about how I could overcome this problem.
Brian
|
|
Message is in Reply To:
3 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
