Subject:
|
Re: gcc build instructions for linux
|
Newsgroups:
|
lugnet.robotics.rcx.legos
|
Date:
|
Wed, 7 Apr 1999 08:25:34 GMT
|
Viewed:
|
3764 times
|
| |
|
|
This site is quite useful:
http://www.objsw.com/CrossGCC
I found it via ftp.cygnus.com/pub/crossgcc. I hope it helps you out.
Cheers,
Vic
In lugnet.robotics.rcx.legos, Dwayne Jacques Fontenot writes:
> I got everything to build using egcs 1.1.2, but I am having problems with
> the tm-and-ir demo (after modifying it for the new execi syntax) which
> make me think maybe egcs is not generating correct code. I used the build
> instructions at http://www.zanshinsys.com/linux-h8300/linuxgcc-h8300-HOWTO.txt
>
> I did use the --enable-target-optspace flag when building egcs. I wonder if
> that is part of the problem.
>
> I will try again a little differently to see if I get better results.
>
> Dwayne
>
> In lugnet.robotics.rcx.legos, Lou Sortman writes:
> > Luis Villa wrote:
> >
> > > I got the same message, and your reasoning about the content of the
> > > message sounds AOK by me. But then I did a make install, and that crudded
> > > out on me, with the message
> > >
> > > In file included from ../../../egcs-1.1.2/gcc/f/com.c:198:
> > > ../../../egcs-1.1.2/gcc/f/com.h:144: #error Cannot find a suitable type
> > > for FFECOM_f2cLONGINT
> >
> >
> > I did not have this problem. Sounds like Fortran. Did you 'make • LANGUAGES="c
> > c++"' or just 'make'? The latter makes the Fortran stuff, too. Remember • that
> if
> > you specify LANGUAGES when building, you should specify the same value when
> > installing.
> >
> > > > > I even tried building using newlib-1.8 to no avail.
> > >
> > > Has anyone else tried this? At least in theory, the improved efficiency
> > > would be worthwile, but I'm curious about compatibility.
> >
> > I have not.
|
|
Message is in Reply To:
 | | Re: gcc build instructions for linux
|
| I got everything to build using egcs 1.1.2, but I am having problems with the tm-and-ir demo (after modifying it for the new execi syntax) which make me think maybe egcs is not generating correct code. I used the build instructions at (URL) did use (...) (28 years ago, 7-Apr-99, to lugnet.robotics.rcx.legos)
|
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
