 | | Re: gcc build instructions for linux
|
|
(...) I got the same message, and your reasoning about the content of the message sounds AOK by me. But then I did a make install, and that crudded out on me, with the message In file included from ../../../egcs-1.1.2/...com.c:198: (...) (26 years ago, 6-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
(...) I did not have this problem. Sounds like Fortran. Did you 'make LANGUAGES="c c++"' or just 'make'? The latter makes the Fortran stuff, too. Remember that if you specify LANGUAGES when building, you should specify the same value when (...) (26 years ago, 6-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
I got everything to build using egcs 1.1.2, but I am having problems with the tm-and-ir demo (after modifying it for the new execi syntax) which make me think maybe egcs is not generating correct code. I used the build instructions at (URL) did use (...) (26 years ago, 7-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
This site is quite useful: (URL) found it via ftp.cygnus.com/pub/crossgcc. I hope it helps you out. Cheers, Vic (...) LANGUAGES="c (...) that (...) (26 years ago, 7-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
OK, I have some more information now. When I build 0.1.6 in my new environment it works fine. 0.1.7 and the snap exhibit the problem. The problem is that when using tm-and-ir, the 'view' button (which is supposed to send the message "Hello World") (...) (26 years ago, 8-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
(...) I observed the same phenomenon, only I was using gcc-2.8.1. I never did find out what was wrong, but I assumed it might have something to do with the new libgcc stuff which appeared in 0.1.7. I eventually got working by installing egcs-1.1.1. (...) (26 years ago, 8-Apr-99, to lugnet.robotics.rcx.legos)
|
