Subject:
|
Re: 1.0 brick not responding
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Wed, 14 Sep 2005 01:38:19 GMT
|
Viewed:
|
9858 times
|
| |
|
|
In lugnet.robotics.rcx, Steve Hassenplug wrote:
> On Tue, September 13, 2005 4:51 pm, Tammy Dunn wrote:
> > In lugnet.robotics.rcx, Steve Hassenplug wrote:
> > >
> > > A couple questions...
> > > 1) Does the light on the IR tower flash when you're trying to communicate?
> > Yes, it flashes.
>
> Generally, that means the IR tower is working. It's possible the tower has become
> broken, while it sat in a closet, but that's not very likely.
>
> So, knowing things worked before, you may be forgetting something.
>
> Make sure the memory is cleared.
> (1) remove batteries with RCX ON
> (2) reinstall batteries.
> This process has always worked for me.
>
> Next, try downloading the firmware again. It takes about 5 minutes.
>
> Keep track of
> (1) how long the download program takes to respond
> (2) what it says when it's finished
>
> Report back...
Powerbook 5300 with MacNQC:
After about 4 seconds "No response or bad response from RCX. Make sure the
RCX's receiver is facing the IR device and the RCX is turned on."
Palm 130 with PBrick Demo:
play sound 1, play sound 2, and play sound 3 "ERROR: No reply"
get battery voltage "ERROR: No reply"
FW "Get versions: ROM:0301, Firmware 0000"
This is with new batteries in both the tower and the brick 1.0
|
|
Message is in Reply To:
 | | Re: 1.0 brick not responding
|
| (...) Generally, that means the IR tower is working. It's possible the tower has become broken, while it sat in a closet, but that's not very likely. So, knowing things worked before, you may be forgetting something. Make sure the memory is cleared. (...) (21 years ago, 13-Sep-05, to lugnet.robotics.rcx)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
