Subject:
|
Re: 1.0 brick not responding
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Mon, 12 Sep 2005 05:57:09 GMT
|
Viewed:
|
4208 times
|
| |
|
|
On Sun, September 11, 2005 7:58 pm, Tammy Dunn wrote:
> mac powerbook 5300 communicates with the IR tower, but no response from the
> brick.
>
> palm 130 with pbrick, also no response from the brick.
>
> The brick powers on and beeps, just no communication with the powerbook or the
> palm for programming. Since it does this with both the palm and the powerbook,
> I'm fairly certain that the IR tower isn't the problem. What would be the most
> common component that could go out in a 1.0 brick that might cause this? I
> would be willing to gamble and try to fix it on the component level if I knew
> the most likely cause.
Tammy,
A couple questions...
1) Does the light on the IR tower flash when you're trying to communicate?
2) Did it ever work (did it work before, but stop, or is this the first time you've
tried communicating?)
3) What are you trying to communicate? (download firmware, program...)
Steve
|
|
Message has 1 Reply:
 | | Re: 1.0 brick not responding
|
| (...) Yes, it flashes. (...) Yes it did work, but it's been in storage for a couple of years. (...) At this point, just download firmware. Once I get the communication issues resolved, I'll do programming. (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | 1.0 brick not responding
|
| mac powerbook 5300 communicates with the IR tower, but no response from the brick. palm 130 with pbrick, also no response from the brick. The brick powers on and beeps, just no communication with the powerbook or the palm for programming. Since it (...) (19 years ago, 12-Sep-05, to lugnet.robotics.rcx)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
