Subject:
|
Re: 1.0 brick not responding
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Tue, 13 Sep 2005 22:05:45 GMT
|
Viewed:
|
4378 times
|
| |
|
|
On Tue, September 13, 2005 4:51 pm, Tammy Dunn wrote:
> In lugnet.robotics.rcx, Steve Hassenplug wrote:
> >
> > A couple questions...
> > 1) Does the light on the IR tower flash when you're trying to communicate?
> Yes, it flashes.
Generally, that means the IR tower is working. It's possible the tower has become
broken, while it sat in a closet, but that's not very likely.
So, knowing things worked before, you may be forgetting something.
Make sure the memory is cleared.
(1) remove batteries with RCX ON
(2) reinstall batteries.
This process has always worked for me.
Next, try downloading the firmware again. It takes about 5 minutes.
Keep track of
(1) how long the download program takes to respond
(2) what it says when it's finished
Report back...
Good Luck
Steve
|
|
Message has 1 Reply:
 | | Re: 1.0 brick not responding
|
| (...) Powerbook 5300 with MacNQC: After about 4 seconds "No response or bad response from RCX. Make sure the RCX's receiver is facing the IR device and the RCX is turned on." Palm 130 with PBrick Demo: play sound 1, play sound 2, and play sound 3 (...) (19 years ago, 14-Sep-05, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | Re: 1.0 brick not responding
|
| (...) Yes, it flashes. (...) Yes it did work, but it's been in storage for a couple of years. (...) At this point, just download firmware. Once I get the communication issues resolved, I'll do programming. (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
