 | | RE: different output power at different ports? —Elizabeth Mabrey
|
| | | (...) Without any precious hardware verification, this is what I did: - symptom: motor C was not able to make turn as well as motor A can - troubleshooting steps: a) to ensure even load on both motor ports, I removed all other attachments, and left (...) (19 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
|
| | | |
| | | | | RE: different output power at different ports? —Elizabeth Mabrey
|
| | | | | Sorry... I meant "precise hardware verification" not precious. I do not the equipment to measure them. Any suggestion, other than getting extra hardware like a power analyzer, for trouble shooting? Trouble shooting is always (well, almost always) (...) (19 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
|
| | | | | |
| | | | | | | RE: different output power at different ports? —Steve Hassenplug
|
| | | | | | On Thu, July 14, 2005 10:12 am, Elizabeth Mabrey said: (...) well, I'm not a precious hardware guru, :) but I find it hard to believe the small difference in the electronics would make a noticeable difference in the output of the motors. If you're (...) (19 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
|
| | | | | | |
| | | | | | | | Re: different output power at different ports? —Thomas Chesney
|
| | | | | | You're absolutely sure it's not a sticky wheel? Thomas (...) (19 years ago, 15-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
|
| | | | | | |
| | | | | Re: different output power at different ports? —danny staple
|
| | | | (...) Okay - did you try a simple program going in a straight line, and check how much it veered after a few meters? Unfortunately - it does not sound an entirely unlikely problem - if there are variations between the h-bridges (general (...) (19 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
|
| | | | |
| | | | | | Re: different output power at different ports? —Ralph Hempel
|
| | | | (...) This sounds to me like a good tactic. Your program might have some issue with turning in one direction vs another. (...) I also have trouble believing variations in parts (except the motors themselves) will cause this much difference. Ralph (19 years ago, 14-Jul-05, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab)
|
| | | | |
