Subject:
|
About IR Tower
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Fri, 23 Feb 2001 08:02:23 GMT
|
Viewed:
|
1569 times
|
| |
|
|
I remember I connected to serial port without power off when I use IR
tower every time, can it let IR tower get fault?
Zhengrong
Zhengrong Zang wrote:
> I haven't used my RCX for a while, I found it doesn't work when I want
> to download firmware to it today. In fact, it is near non working!
> The RCX2 tools, nqc, lejos and WinNQC all can't find this RCX, but it
> can be found in 1% chance even if I put it next to IR Tower, does it
> mean my RCX no longer works? does anyone has same experience?
|
|
Message has 1 Reply:
 | | Re: About IR Tower
|
| The tower must be connected before you boot the computer. Have you tried using the other COM port? If your mouse is using the other port, swap it and try the tower in that port. Remember to reboot. If all else fails, you need a friend to loan you a (...) (24 years ago, 23-Feb-01, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | My RCX doesn't work!
|
| I haven't used my RCX for a while, I found it doesn't work when I want to download firmware to it today. In fact, it is near non working! The RCX2 tools, nqc, lejos and WinNQC all can't find this RCX, but it can be found in 1% chance even if I put (...) (24 years ago, 23-Feb-01, to lugnet.robotics.rcx)
|
10 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
