 | | Re: error in using brickOS under Bricx Command Center
|
|
(...) 1. What version of brickos do you have installed? (cat VERSION from the brickos root directory and post the output) 2. What do you mean by "Of course I did in vain."? Be as precise as possible in your answer. With a correctly installed copy of (...) (19 years ago, 19-Oct-05, to lugnet.robotics.rcx.legos)
|
| |
| | Re: error in using brickOS under Bricx Command Center
|
|
(...) As I said before, I am able to use brickOS under cygwin. Does this mean that I have files required by brickOS? I guess you don't mean that I have to run the two commands: make realclean make (Of course I did in vain.) Je-Young Choi (19 years ago, 19-Oct-05, to lugnet.robotics.rcx.legos)
|
| |
| | Re: NQC/BricxCC test
|
|
(...) Only if active is meant to cause the watch window to quit polling for values if some other BricxCC window is the active window. When graphing this means that after you bring up the graph window you need to click back on the Watch window to (...) (19 years ago, 18-Oct-05, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: error in using brickOS under Bricx Command Center
|
|
(...) I have dug around a bit on my computer and I managed to duplicate your problem. If I do a make realclean from the brickOS root directory: C:\cygwin\brickos>make realclean [lots of output delete] then when I run make -f helloworld.mak I get the (...) (19 years ago, 18-Oct-05, to lugnet.robotics.rcx.legos)
|
| |
| | Re: NQC/BricxCC test
|
|
(...) Duh! I had 'only if active' ticked and I dont suppose that changes in my light sensor were enough to trigger it. I now have watching the brick & graphing working! I notice that (unused) counter 0 and 1 take on the values of var 0 and 1 and (...) (19 years ago, 18-Oct-05, to lugnet.robotics.rcx.nqc)
|
