Subject:
|
Re: NQC/BricxCC test
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Tue, 18 Oct 2005 16:15:34 GMT
|
Viewed:
|
5797 times
|
| |
|
|
In lugnet.robotics.rcx.nqc, Charles Tomkins wrote:
>
> I wasn't able test out the new (Vers.10) graphing part as I dont yet understand it.
Duh! I had 'only if active' ticked and I dont suppose that changes in my light
sensor were enough to trigger it. I now have watching the brick & graphing
working! I notice that (unused) counter 0 and 1 take on the values of var 0 and
1 and that variables declared inside a task cannot be read, but perhaps this is
all how it should be :-)
One small thing: If I open and modify an existing program and accidently go to
close Bricx the program notices that 'the file has been modified' but when I
try to cancel the closing (in order to be able to 'save as' under a different
name) Bricx just closes rather than cancelling.
Many thanks
|
|
Message has 1 Reply:
 | | Re: NQC/BricxCC test
|
| (...) Only if active is meant to cause the watch window to quit polling for values if some other BricxCC window is the active window. When graphing this means that after you bring up the graph window you need to click back on the Watch window to (...) (19 years ago, 18-Oct-05, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
| | Re: NQC/BricxCC test
|
| (...) This seems to have fixed all the problems that I was having with the serial tower and Bricx. [It also downloaded new (Swan)firmware OK] The template right-click is great too :-) I wasn't able test out the new (Vers.10) graphing part as I dont (...) (19 years ago, 18-Oct-05, to lugnet.robotics.rcx.nqc)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
