 | | Re: Add motor driver to RCX
|
|
(...) I'm working on a scheme to do that sort of thing. I propose to use opto-couplers with their LEDs in reverse parallel, connected to the RCX output, and their transistors driving a power H-bridge powered from a separate supply. I can't see any (...) (20 years ago, 31-Jul-04, to lugnet.robotics.rcx)
|
| |
| | Updated BrickOS Command Reference
|
|
Hello, Cleaned up the LegOS 0.2.4 Command Reference that I'd written like almost 4 years ago (has it been that long?!!) at the BrickOS site so that it is now current with BrickOS 0.2.6.10. Find it here: (URL) let me know if there are any errors, (...) (20 years ago, 31-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Full IR packet networking
|
|
When I was looking over version 0.2.0, I saw that one of the features was Full IR packet networking. My question is what exactly does Full IR packet networking do. Does this capability allow individual RCX to be networked, meaning they can (...) (20 years ago, 30-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Kernel size
|
|
Hi Andreas, (...) It is about 22cm x 12cm for the two dimensional kernel. (couldn't resist) Actually, the size of the kernel is sort of unknown until you built it. It depends on your preferences and to some degree of the compiler version you build (...) (20 years ago, 29-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Kernel size
|
|
Hi, I've got a really small question. What's the size of the LegOS Kernel which you have to load on the RCX? Andreas (20 years ago, 29-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem
|
|
Trent, Make sure the following files exist in the paths listed below (within the main BrickOS folder): boot\brickos.srec util\firmdl3.exe If those do not exist, then you need to run the configuration routine and MAKE to build the firmdl3 application (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Beginners questions
|
|
(...) Hi Glenn, I don’t have answers to your questions but think Mitchell has the right idea. I did want to post a couple of links to some coaching resources that I put together, many of them related to Robolab, that FLL coaches or teachers might (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.robolab, FTX)
|
| |
| | Re: Beginners questions
|
|
(...) If you haven't done so already I would suggest writing to the source: (URL) if you get an answer please post it as I would be intrested (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.robolab, FTX)
|
| |
| | Re: Problem
|
|
(...) You'd be up and running already without a hitch if you used my pre-built installers for cygwin & brickOS. Downloading the firmware using BricxCC is very simple as well. (URL) Hansen (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Add motor driver to RCX
|
|
Have anyone tried to add an external motordriver to the RCX ports, so you can use the powerful 3Amp motors from the 8366 RC car on the RCX? (20 years ago, 26-Jul-04, to lugnet.robotics.rcx)
|
