 | | Re: Proper power supply for a 1.0?
|
|
(...) I'd like to be cutting in to this transformer conversation, since ... I'd like to know what kind of adapter I could use (and how) for supplying my RCX with power, since it has no inlet. I have tried to use DC adapters for 6, 9, and 12 Volts, (...) (23 years ago, 23-Aug-01, to lugnet.robotics.rcx)
|
| |
| | Re: New release of leJOS for Windows
|
|
I followed the link but can't see any mention of the hardware compatibility of leJOS. Is anyone involved with the project planning to test it against the new RCX 2.0 brick and USB tower? Mark. (...) (23 years ago, 23-Aug-01, to lugnet.robotics.rcx.java)
|
| |
| | Re: Proper power supply for a 1.0?
|
|
(...) I've used the Train Transformers with great success. If you look close at your RCX you'll notice 9-12~ Anything from 9 to 12 volts AC or DC will work fine. Though to prevent your RCX's Diode Bridge from burning out AC is better. (Shares the (...) (23 years ago, 23-Aug-01, to lugnet.robotics.rcx)
|
| |
| | Re: Proper power supply for a 1.0?
|
|
(...) Well on the back of the LEGO train power supply it list Output as 12VAC 7VA, so I'm assuming that the DC conversion is done in the speed regulator, I couldn't tell you why. But it's good to know I can use this power supply with a 1.0 RCX since (...) (23 years ago, 23-Aug-01, to lugnet.robotics.rcx)
|
| |
| | Re: Be VERY careful with that train transformer (was:Proper power supply for a 1.0?)
|
|
(...) heh, notice that the original question was about the "power supply that goes with the 0v train spee dregulator" - so we're talking about lego transformers, not just any train transformer. :) (23 years ago, 23-Aug-01, to lugnet.robotics.rcx)
|
