Subject:
|
Re: Using NXT Port 4 EIA-485
|
Newsgroups:
|
lugnet.robotics.nxt
|
Date:
|
Sun, 8 Apr 2007 14:19:54 GMT
|
Viewed:
|
19558 times
|
| |
|
|
In lugnet.robotics.nxt, Christian Mock wrote:
> Hi,
> is there currently any software-support (pbLua, NXT-G, NXJ) for NXT Port4
> highspeed serial communication (EIA-485) ?
> Thanks for more informations
> Christian
As far as I know, there isn't any support for this interface in either the
standard firmware or any of the other third party firmware implementations.
The interface runs at 921,600 bps so it will be fast enough to be really useful.
I am hoping that, eventually, it will be supported.
JB
|
|
Message has 2 Replies:
 | | Re: Using NXT Port 4 EIA-485
|
| (...) What is not supported about this port in the standard NXT firmware? You can read from it and write to it using the IOMapRead and IOMapWrite syscall functions. Looking at the firmware source code it certainly looks like everything is setup to (...) (18 years ago, 9-Apr-07, to lugnet.robotics.nxt)
|
Message is in Reply To:
| | Using NXT Port 4 EIA-485
|
| Hi, is there currently any software-support (pbLua, NXT-G, NXJ) for NXT Port4 highspeed serial communication (EIA-485) ? This port can be used for connecting some new hardware (camera, SD-Card-storage) to the NXT... Thanks for more informations Bye (...) (18 years ago, 7-Apr-07, to lugnet.robotics.nxt)
|
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
