Subject:
|
Using NXT Port 4 EIA-485
|
Newsgroups:
|
lugnet.robotics.nxt
|
Date:
|
Sat, 7 Apr 2007 12:15:07 GMT
|
Viewed:
|
19029 times
|
| |
|
|
Hi,
is there currently any software-support (pbLua, NXT-G, NXJ) for NXT Port4
highspeed serial communication (EIA-485) ?
This port can be used for connecting some new hardware (camera, SD-Card-storage)
to the NXT...
Thanks for more informations
Bye
Christian
|
|
Message has 2 Replies:
 | | Re: Using NXT Port 4 EIA-485
|
| (...) As far as I know, there isn't any support for this interface in either the standard firmware or any of the other third party firmware implementations. The interface runs at 921,600 bps so it will be fast enough to be really useful. I am hoping (...) (18 years ago, 8-Apr-07, to lugnet.robotics.nxt)
| | | Re: Using NXT Port 4 EIA-485
|
| (...) Christian, There is currently no direct support for this in pbLua, but it's not too hard to add. The HighSpeed port is port 4, and it has basically 3 wires that control how it works. PA4/5 are the RX and TX to UART0 right on the ARM PA7 is RTS (...) (18 years ago, 16-Apr-07, to lugnet.robotics.nxt)
|
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
