To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 8449
8448  |  8450
Subject: 
Question about necessary tools for HB assembly
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Fri, 24 Aug 2001 22:16:19 GMT
Viewed: 
1789 times
  
Howdy all,

I'm getting ready to finally begin assembly of my HB and I have a question
regarding the "necessary" tools for this.  In the assembly guide, the last
tool it states as needed is a Logic Probe or Oscilloscope.  I've used
O-scopes before but don't happen to own one myself.  The logic probe sounds
more reasonable except that I don't know what it is or where to get one
(Radio Shack or Fry's I'm assuming).  Also, is it possible to use anything
else in place of these tools?  O-scopes are a bit out of my price range and
if the Logic probe is also expensive then I may be up a creek trying to
finish building this.  Thanks.

Scott



Message has 1 Reply:
  Re: Question about necessary tools for HB assembly
 
Hi Scott, I assembled three 6.270 boards (kind of grandpa of handyboard) some month ago and didn't need an Oscilloscope or a Logic Probe. I guess you'll only need such things if you run into trouble with getting started with your handyboard. So, try (...) (23 years ago, 26-Aug-01, to lugnet.robotics.handyboard)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR