To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 8451
8450  |  8452
Subject: 
Re: Question about necessary tools for HB assembly
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Sun, 26 Aug 2001 21:21:31 GMT
Viewed: 
1781 times
  
Hi Scott,

I assembled three 6.270 boards (kind of grandpa of handyboard) some month
ago and didn't need an Oscilloscope or a Logic Probe.

I guess you'll only need such things if you run into trouble with getting
started with your handyboard.

So, try to assemble it and follow the steps of the handy board manual and
you may (will?) succeed.

Regards,

Rainer


In lugnet.robotics.handyboard, Scott Hazel writes:
Howdy all,

I'm getting ready to finally begin assembly of my HB and I have a question
regarding the "necessary" tools for this.  In the assembly guide, the last
tool it states as needed is a Logic Probe or Oscilloscope.  I've used
O-scopes before but don't happen to own one myself.  The logic probe sounds
more reasonable except that I don't know what it is or where to get one
(Radio Shack or Fry's I'm assuming).  Also, is it possible to use anything
else in place of these tools?  O-scopes are a bit out of my price range and
if the Logic probe is also expensive then I may be up a creek trying to
finish building this.  Thanks.

Scott



Message has 1 Reply:
  Re: Question about necessary tools for HB assembly
 
Thanks for the info Rainer. I ended up picking up a Logic Probe from Radio Shack as it was only $18. Even if its not top of the line, it should work plenty fine for this job (and more later). If I get more serious about building these kits and the (...) (23 years ago, 29-Aug-01, to lugnet.robotics.handyboard)

Message is in Reply To:
  Question about necessary tools for HB assembly
 
Howdy all, I'm getting ready to finally begin assembly of my HB and I have a question regarding the "necessary" tools for this. In the assembly guide, the last tool it states as needed is a Logic Probe or Oscilloscope. I've used O-scopes before but (...) (23 years ago, 24-Aug-01, to lugnet.robotics.handyboard)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR