 | | Connecting RX to Handyboard
|
|
Hi all, I'd like to build a radio controlled robot and I wish to connect a radio receiver normally used for model airplanes to the Handyboard so it can receive the commands I send from the transmitter, check for sensor and then activate servos that (...) (22 years ago, 12-Feb-02, to lugnet.robotics.handyboard)
|
| |
| | Srial problem
|
|
Hi. I am putting together a Handyboard and have been having success until it came time to test the bootstrap mode. The interface board's voltages check out and it blinks as it attempts to download. I am using an E1 and the Mac 6811 downloader. The E (...) (22 years ago, 9-Feb-02, to lugnet.robotics.handyboard)
|
| |
| | Re: Sensor Connector
|
|
The LEGO shaft encoder and light sensor are active sensors that need a special circuit. The Expansion Board for the HB provides this ckt and the requisite drivers. Your simplest path to using these with the HB is to get an Exp Bd. Barring that, you (...) (22 years ago, 7-Feb-02, to lugnet.robotics.handyboard)
|
| |
| | Re: Sensor Connector
|
|
(...) Thanks, I thought there might be a special connector but I see now that its a standard enough connector. Another question: How can I get the handy board to read from the lego rotation sensor and the lego light sensor? I can get the touch (...) (22 years ago, 7-Feb-02, to lugnet.robotics.handyboard)
|
| |
| | Re: Sensor Connector
|
|
Info on doing this is at (URL) . The male strip header is 929400-01-36-ND from Digikey. Fred (...) (22 years ago, 6-Feb-02, to lugnet.robotics.handyboard)
|
