Subject:
|
Connecting RX to Handyboard
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 12 Feb 2002 18:48:58 GMT
|
Viewed:
|
6795 times
|
| |
|
|
Hi all,
I'd like to build a radio controlled robot and I wish to connect a radio
receiver normally used for model airplanes to the Handyboard so it can
receive the commands I send from the transmitter, check for sensor and then
activate servos that are connected to the Handyboard and not directly to the
receiver as on model airplanes.
My doubt is that servos don't accept a normal analog signal but a PWM
signal, so I suppose, the RX sends a PWM code and not an analog signal. How
can I let Handyboard read signals from the RX?
I hope someone can help me. Thank you very much (and excuse me for my bad
english :) )
--
Claudio Nigro
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
