 | | Re: Question about necessary tools for HB assembly
|
|
Hi Scott, I assembled three 6.270 boards (kind of grandpa of handyboard) some month ago and didn't need an Oscilloscope or a Logic Probe. I guess you'll only need such things if you run into trouble with getting started with your handyboard. So, try (...) (25 years ago, 26-Aug-01, to lugnet.robotics.handyboard)
|
| |
| | Serial LED is not lighting up during charger board assembly
|
|
I'm in the middle of assembling the Serial Interface and Batt. Charger board but have run into a snag. While testing the serial circuit, I was able to see the +-9V values on pin 2 of U16. However, when testing the transmit and receive functions of (...) (25 years ago, 25-Aug-01, to lugnet.robotics.handyboard)
|
| |
| | Question about necessary tools for HB assembly
|
|
Howdy all, I'm getting ready to finally begin assembly of my HB and I have a question regarding the "necessary" tools for this. In the assembly guide, the last tool it states as needed is a Logic Probe or Oscilloscope. I've used O-scopes before but (...) (25 years ago, 24-Aug-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Help neeeded in S19
|
|
Hi Chee, I used the assembler code of this shaft encoder software to create my own. Although using them in C is quite simple, programming in assembler much toucher - but very nice. Take a look at my website (URL) for the altered shaft encoder code. (...) (25 years ago, 23-Aug-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Help neeeded in S19
|
|
Hi To solve your problem you don't need to learn s19 code. You must only something like encoder0_low_threshold= 75; in your program (c and nod s19). You must only replace the 0 (zero) according to your used analog port. For further information refer (...) (25 years ago, 22-Aug-01, to lugnet.robotics.handyboard)
|
