|
|
 | | PCB Designs
|
| HI Any of you guys out there in robo land have any good PCB designs for high powered motor driver, IRPD's or a nice Handy Boardish thing that you dont know what to call. Thanx -roboman PS Got a PCB etcher system for XMAS and want some PCB designs (...) (25 years ago, 12-Jan-00, to lugnet.robotics.handyboard)
| | | | | Re: "Traces"?
|
| (...) 'Trace', and 'track', are common parlance, for the wiring built onto the printed circuit board inside a unit. So the post is saying that you have to actually cut the copper 'tracks' inside the unit itself. Best Wishes (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | "Traces"?
|
| (...) I've seen "trace" used a couple times as regards the Handyboard, concerning the leads from/to the inputs, I think??? What does it mean, what are they? Thx :) - Scarius (URL) (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | Re: GP2D12 Pinouts
|
| (...) Just visit: (URL) are some modifications to the handyboard required, because the sensor does not work with the pull-up resistors on the handyboard. You have to cut some traces on the handyboard. A detailed description and a picture of the (...) (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | GP2D12
|
| I just managed to connect a Sharp GP2D12 to my Handyboard. The advantage compared to the GP2D02-device is the analog output which does not consume processing power for clocking the sensor. Further information can be found at: (URL) (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
|
|
