| |
Dirk Stueker wrote:
> There are some modifications to the handyboard required,
> because the sensor does not work with the pull-up resistors
> on the handyboard. You have to cut some traces on the handyboard.
I've seen "trace" used a couple times as regards the Handyboard,
concerning the leads from/to the inputs, I think??? What does it mean,
what are they?
Thx :)
- Scarius
http://weaselworks.cjb.net/
|
|
Message has 1 Reply:
 | | Re: "Traces"?
|
| (...) 'Trace', and 'track', are common parlance, for the wiring built onto the printed circuit board inside a unit. So the post is saying that you have to actually cut the copper 'tracks' inside the unit itself. Best Wishes (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
