| |
In lugnet.robotics.handyboard, Joe Kopena writes:
> Dirk Stueker wrote:
> > There are some modifications to the handyboard required,
> > because the sensor does not work with the pull-up resistors
> > on the handyboard. You have to cut some traces on the handyboard.
>
> I've seen "trace" used a couple times as regards the Handyboard,
> concerning the leads from/to the inputs, I think??? What does it mean,
> what are they?
'Trace', and 'track', are common parlance, for the wiring built onto the
printed circuit board inside a unit. So the post is saying that you have to
actually cut the copper 'tracks' inside the unit itself.
Best Wishes
|
|
Message has 1 Reply:
Message is in Reply To:
 | | "Traces"?
|
| (...) I've seen "trace" used a couple times as regards the Handyboard, concerning the leads from/to the inputs, I think??? What does it mean, what are they? Thx :) - Scarius (URL) (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
