 | | "Traces"?
|
| (...) I've seen "trace" used a couple times as regards the Handyboard, concerning the leads from/to the inputs, I think??? What does it mean, what are they? Thx :) - Scarius (URL) (27 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | Re: GP2D12 Pinouts
|
| (...) Just visit: (URL) are some modifications to the handyboard required, because the sensor does not work with the pull-up resistors on the handyboard. You have to cut some traces on the handyboard. A detailed description and a picture of the (...) (27 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | GP2D12
|
| I just managed to connect a Sharp GP2D12 to my Handyboard. The advantage compared to the GP2D02-device is the analog output which does not consume processing power for clocking the sensor. Further information can be found at: (URL) (27 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | RE: More servo stuff
|
| I had the same problem. The servo would run fine if the program was not doing anything else. But if I was updating the pwm to the motor ports then the servo would jitter. I figured it was because the extra overhead was screwing up the timing on the (...) (27 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
| | | | | Re: More servo stuff
|
| (...) I did this but it didn't help. *sigh* Thanks for the tip! (27 years ago, 10-Jan-00, to lugnet.robotics.handyboard)
|
|
