| |
> Try placing a capacitor across +5V and ground. Get something in the range
> of 0.1 - 0.47 microfarads and just plug it into the headers on the HB. This
> solved my problems.
I did this but it didn't help. *sigh*
Thanks for the tip!
|
|
Message has 1 Reply:
 | | RE: More servo stuff
|
| I had the same problem. The servo would run fine if the program was not doing anything else. But if I was updating the pwm to the motor ports then the servo would jitter. I figured it was because the extra overhead was screwing up the timing on the (...) (25 years ago, 11-Jan-00, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | Re: More servo stuff
|
| Try placing a capacitor across +5V and ground. Get something in the range of 0.1 - 0.47 microfarads and just plug it into the headers on the HB. This solved my problems. -Scott Harris (...) (25 years ago, 10-Jan-00, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
